Operations Guide

This section defines the pre-requisites installation and steps for setup of a DLT network. If this is your first time, do refer to Key-Concepts, Getting-Started and Architecture-References before moving ahead.

Pre-requisites

• Install Common Pre-requisites
• Additional Prerequisites for own Ansible Controller
• Configure Common Pre-requisites

Fabric operations

• Configuration file specification: Hyperledger-Fabric
• Upgrading Hyperledger Fabric version
• Adding a new organization in Hyperledger Fabric
• Adding a new Orderer organization in Hyperledger Fabric
• Adding a new channel in Hyperledger Fabric
• Removing an organization in Hyperledger Fabric
• Adding a new peer to existing organization in Hyperledger Fabric
• Adding a new RAFT orderer to existing Orderer organization in Hyperledger Fabric
• Installing and instantiating chaincode in Bevel deployed Hyperledger Fabric Network
• Upgrading chaincode in Hyperledger Fabric
• Deploying Fabric Operations Console
• Refresh certificates in Hyperledger Fabric

Corda operations

• Configuration file specification: R3 Corda
• Adding cordapps to R3 Corda network
• Adding a new organization in R3 Corda
• Adding a new Notary organization in R3 Corda Enterprise

Besu operations

• Configuration file specification: Hyperledger Besu
• Adding a new member organization in Besu
• Adding a new validator node in Besu
• Adding a new validator organization in Besu

Indy operations

• Configuration file specification: Indy
• Adding a new validator organization in Indy

Quorum operations

• Configuration file specification: Quorum
• Adding a new node in Quorum

Generic operations

• Setting up a DLT/Blockchain network
• How to debug a Bevel deployment
• Adding a new storageclass
• Upgrading a running helm2 Bevel deployment to helm3